LazyDriver
Users manual
Required Tools:
- Pliers
- Screwdriver
Jaguar XJ
Somewhen in future
Jaguar X-Type
Jaguar S-Type
Somewhen in future
PRE-ORDERS OPEN: LINK TO ORDER
Install Android App: Download .APK
Step 1
Installation
Step 2
Operation
Key Features of LazyDriver
Extension of turn signal duration
Hazard lights activation during sudden braking
Hazard lights activation when reverse gear is engaged
“Thank You” function
If you press the turn signal with a single touch (not to the click position), it will continue to operate for a specified period of time (default is 5 flashes) and then turn off automatically.
Each subsequent touch restarts the cycle.
To cancel the turn signal, activate the turn signal in the opposite direction.
When sudden braking is detected, the hazard lights are activated to alert other road users.
The hazard lights flash rapidly for a specified period of time (default is 2.5 seconds).
By default, the sensor sensitivity is set to a medium value (-0.7g).
When reverse gear is engaged, the hazard lights automatically turn on (with a 1-second delay).
When reverse gear is disengaged, the hazard lights automatically turn off.
By default, this function is enabled (ON).
Press and hold the hazard lights button for 1 second.
Release the button. The hazard lights will continue to operate for a specified period of time (default is 2.5 seconds) and then turn off automatically.
By default, this function is disabled (OFF).
Step 3
Adjustment / Setup
Turn the ignition to position II.
With a single touch, activate and immediately cancel either turn signal 5 times in a row. That is, turn it on and then off, repeating this sequence 5 times.
After the 5th cancellation, the hazard lights will activate (a series of rapid flashes).
You may now proceed to the settings.
To exit the menu, simply wait for 3 seconds until the hazard lights activate (a series of rapid flashes).
All settings made in the menu are stored in non-volatile memory. This means that the settings you have chosen will be saved even after turning off the ignition and disconnecting the battery.
Adjusting the turn signal duration
Press and hold the turn signal for the desired amount of time.
Adjusting the sensitivity of the brake sensor (G-sensor)
Briefly (< 0.5 seconds), press the hazard lights button.
The first press will display the current sensitivity.
The system response will be as follows:
0 flashes of hazard lights: Off
1 flashes of hazard lights: Very high (-0.5g)
2 flashes of hazard lights: High (-0.6g)
3 flashes of hazard lights: Medium (-0.7g)
4 flashes of hazard lights: Low (-0.8g)
5 flashes of hazard lights: Very low (-0.9g)
Enabling / disabling hazard lights function when reversing
Engage and disengage reverse gear.
System response:
1 flash of hazard lights: Off.
2 flash of hazard lights: On.
Enabling / disabling the “Thank You” function
Briefly (< 0.5 seconds), press any of the turn signal indicators.
The system response will be:
1 flash of hazard lights: Off.2 flashes of hazard lights: On.
Factory reset
Press and hold the hazard lights button for 10 seconds. Release the button. The hazard lights will automatically turn off, and after a few seconds, they will start flashing rapidly (a series of rapid flashes).
The default values are provided in the table.
You can perform a reset if the module is not in programming mode (in the settings menu) and if reverse gear is not engaged*.
* If you have connected the green wire to the reverse light during the module installation stage.
